[fedora-arm] Re: Fedora 27 not boot on BBB

Hi Dennis and Peter,

Of course I tried both pushing button and without it, but the result
was the same.
I remember the specification of the first version of the boot program
was designed as what you said.
I probably re-programmed the boot program according to the Ubuntu
without pushing the boot button
in order to boot from SD card.

--
桜井 <sakurai@pugpug.org>


2018-03-14 1:58 GMT+09:00 Peter Robinson <pbrobinson@gmail.com>:
> On Tue, Mar 13, 2018 at 1:51 PM, sakurai <sakurai@pugpug.org> wrote:
>> 2018-03-13 8:18 GMT+09:00 Peter Robinson <pbrobinson@gmail.com>:
>>> On Mon, Mar 12, 2018 at 10:47 PM, sakurai <sakurai@pugpug.org> wrote:
>>>> Hi Peter,
>>>>
>>>> Thank you for your prompt comment.
>>>> I removed uEnv.txt but following message was displayed.
>> (snip)
>>>
>>> I don't know what you've done to now, you're likely possibly better
>>> off starting again with arm-image-installer to setup the image again
>>> with am335x_evm and then try booting with the boot button held down.
>>
>> I tried again using arm-image-installer by following command.
>>
>>> fedora-arm-image-installer --image=Fedora-Server-armhfp-27-1.6-sda.raw.xz --target=am335x_evm --media=/dev/sdd --norootpass --resizefs --addconsole --selinux=off
>>
>> Not am335x_boneblack? Anyway I installed using arm335x_evm this time.
>>
>> My boot loader may be new because Angstrom will not boot without
>> holding the boot button.
>>
>>> You might also want to give the full output.
>>
>> Here is the full output.
>>
>> U-Boot SPL 2013.04-dirty (Jun 19 2013 - 09:57:14)
>> musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn)
>> musb-hdrc: MHDRC RTL version 2.0
>> musb-hdrc: setup fifo_mode 4
>> musb-hdrc: 28/31 max ep, 16384/16384 memory
>> USB Peripheral mode controller at 47401000 using PIO, IRQ 0
>> musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn)
>> musb-hdrc: MHDRC RTL version 2.0
>> musb-hdrc: setup fifo_mode 4
>> musb-hdrc: 28/31 max ep, 16384/16384 memory
>> USB Host mode controller at 47401800 using PIO, IRQ 0
>> OMAP SD/MMC: 0
>> mmc_send_cmd : timeout: No status update
>> reading u-boot.img
>> reading u-boot.img
>>
>>
>> U-Boot 2013.04-dirty (Jun 19 2013 - 09:57:14)
>
> As Dennis had already stated this isn't Fedora's u-boot, what you see
> is as I would expect, basically the problem here is dealing with the
> boot button correctly.
_______________________________________________
arm mailing list -- arm@lists.fedoraproject.org
To unsubscribe send an email to arm-leave@lists.fedoraproject.org