[fedora-arm] Re: CMA on raspberry pi 4

On Mon, Apr 27, 2020 at 6:49 PM <ng0177@gmail.com> wrote:

Hi,

Thomas A's advice works on my RPi 4B and is prerequisite for using the Workstation 32 edition on it.

Thanks for testing it. It is still just a work-around and we need to find a real fix for this. It does hint to what real problem could be though. Debugging further is difficult as the usb controller is one of the things that break. I have a ordered a cable for serial connection and will continue to look into it when it arrives. 

  

Here is my cookbook:

https://dl.fedoraproject.org/pub/fedora-secondary/development/32/Workstation/aarch64/images/

xzcat ./ | sudo dd status=progress bs=1M of=/dev/sdx && sync

Consider taking a look at arm-image-installer. I does mostly the same but has some convenient extra features.

EFI/fedora/grub.cfg
EFI/fedora/grubenv
cma=256M@704M

I end up with an apparenlty fully functional Fedora and after deactivation of animation effects using Tweaks, Gnome is not (very) sluggish and works fine for me.

Cheers, Thomas B

On Thu, Apr 23, 2020 at 5:46 PM Thomas H.P. Andersen <phomes@gmail.com> wrote:

Hi,

I have looked into the CMA setting issue a bit. This is what I have found so far.

The rpi4 needs CMA to be in ZONE_DMA (lower 1GB of memory) as this is the only area that the peripherals on the rpi4 can address.

The DT sets the allowed range to allocate the CMA from (arch/arm/boot/dts/bcm2711.dtsi#L869), but it seems to not work here. What does work is instead to set the offset manually. I replaced "cma=256MB" with "cma=256M@704M" and then it boots. Note that it has to be 256M instead of 256MB.

Removing the cma option on the command line was known as a workaround. Without that we would fall back to the build config of 64MB cma which was located at offset 0x38000000. This left 64MB at the end of ZONE_DMA, and I chose offset 704M so that those 64MB would still be free. Not sure if that is needed or not. The crashkernel needs to be in ZONE_DMA as well but it seems to be set to 0 size.

I have tested on 5.7 rc2 from rawhide.

This probably belongs in a bug report. What would be the correct place to file that? From what I can tell upstream has been tested with cma settings without problems (as long as the requested CMA size can fit in ZONE_DMA). From that it seems like fedora-specific issue. Not sure though.

Cheers,

Thomas

_______________________________________________
arm mailing list -- arm@lists.fedoraproject.org
To unsubscribe send an email to arm-leave@lists.fedoraproject.org
Fedora Code of Conduct: https://docs.fedoraproject.org/en-US/project/code-of-conduct/
List Guidelines: https://fedoraproject.org/wiki/Mailing_list_guidelines
List Archives: https://lists.fedoraproject.org/archives/list/arm@lists.fedoraproject.org