Tuesday, August 22, 2023

[fedora-arm] Re: U-Boot testing request - 2023.10 series

Hello, Peter.

On Saturday, 19 August 2023 at 19:53, Peter Robinson wrote:
> Hi Folks,
> The 2023.10 RC series are now landing in F-39 and rawhide. There's
> been the beginnings of a few enhancements.
> The first one that is noticeable is a bootmenu during the firmware
> init process where it will allow you to select the device/partition
> you wish to boot from, with the default selected and the usual time
> out. It should make things a little easier for things like
> reinstalling off a USB stick for devices that support that sort of
> install.
> I've done some testing across a bunch of devices, various RPi, the
> Pinebook pro and numerous SBCs so I think it should work just fine, at
> least be no different than the usual process but I'd like to hear any
> feedback.

I copied the Pinebook Pro u-boot binaries from
from /usr/share/uboot/pinebook-pro-rk3399/ to a μSD card (previously
formatted using spi-flashing disk script). Then I did the steps from
https://nullr0ute.com/2021/05/fedora-on-the-pinebook-pro/ "Write the
firmware to flash" section.

Unfortunately, after reset (or power-off/power-on cycle), I get this:
U-Boot SPL 2023.10-rc3 (Aug 21 2023 - 00:00:00 +0000)
Trying to boot from SPI
Trying to boot from MMC1
mmc_load_image_raw_sector: mmc block read error
Trying to boot from SPI
Trying to boot from MMC2
Card did not respond to voltage select! : -110
spl: mmc init failed with error: -95
SPL: failed to boot from all boot devices
### ERROR ### Please RESET the board ###

I checked the spi-flashing-disk script, and all it does is create a vfat
formatted partition and copy the 4 binaries from the directory
corresponding to the board model. I think I did everything correctly, so
is the new u-boot broken on PBP?

Fedora https://fedoraproject.org
There should be a science of discontent. People need hard times and
oppression to develop psychic muscles.
-- from "Collected Sayings of Muad'Dib" by the Princess Irulan
arm mailing list -- arm@lists.fedoraproject.org
To unsubscribe send an email to arm-leave@lists.fedoraproject.org
Fedora Code of Conduct: https://docs.fedoraproject.org/en-US/project/code-of-conduct/
List Guidelines: https://fedoraproject.org/wiki/Mailing_list_guidelines
List Archives: https://lists.fedoraproject.org/archives/list/arm@lists.fedoraproject.org
Do not reply to spam, report it: https://pagure.io/fedora-infrastructure/new_issue

No comments:

Post a Comment